Revolabs 10-FLX2-002-VOIP Specifications download pdf (Page 48)

LED Pairing Indicators:

Speaker Indicator

Status

Steady Red

Speaker is in Pairing Mode, either waiting or pairing in progress

Slow red- green flash

Pairing failed or timed out

Green flash

Pairing successful

Microphone Indicator

Status

Steady Red

Pairing Mode, either waiting or pairing in progress

Slow red – green flash

Pairing failed or timed out

Green flash

Pairing successful

Network Settings

1. Browse to the Network Settings menu: Menu  Setup 

Advanced Setup  Network Settings.

a. You can change the DHCP configuration by turning it

off and manually setting your IP address in the IP

Settings. If DHCP is set to ON this takes precedent

over static IP settings.

b. IP Settings allows you to set the IP Address, Subnet

Mask, Default Gateway, Primary DNS and Secondary

DNS when you are not using DHCP.

c. VoIP Settings allow you to set minimal

required settings to connect to a VoIP

switch. Registrar, Username, and

Password (which can be empty) are

required fields to connect to your IP PBX.

i. ‘Registrar’ is either the IP address or

server name of your IP PBX.

ii. ‘ID’ is the name used in messages to

identify this phone. If ID is left open,

the Username will be used as ID.

iii. ‘Display Name’ is the string that is

shown at the far side when you make

outbound calls. If you do not provide

a Display Name, the Username will

be used. Please note that your IP

PBX might override the Display name sent by

the FLX and replace it with names configured

in the PBX.

iv. ‘Username’ is the extension off the IP PBX this

phone will be reached under

v. ‘Password’ is the password used by the

Username to logon to the IP PBX.

vi. If any value was changed, a sixth option ‘Load

Settings’ is offered. This will reboot the FLX

Base Station, applying the changed settings.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 89 90

Comments to this Manuals

No comments

Revolabs 10-FLX2-002-VOIP Specifications Page 48

Comments to this Manuals