Revolabs Single Channel System - Polycom HDX 9004 User Manual download pdf

Revolabs Single Channel System - Polycom HDX 9004 Setup Guide

NOTES AND CA UTIONS:

This setup guide will guide you through the steps needed to properly connect a

Revolabs Single Channel System to a Polycom HDX 9004 video codec.

1. Connecting the Cables

2. Configuring the HDX 9004 Video Codec

Note:

It is important to carefully follow these instructions in order and completely .

Otherwise your Single Channel System and/or the video codec may not function

properly. Please read through these instructions completely before proceeding.

Contact Revolabs technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs Single Channel System

2. Revolabs 2.5mm to RCA Audio Cable (included with Single Channel)

3. Polycom HDX 9004 video codec

4. Polycom Audio Adapter Cable (P/N 2457-23492-001) or equivalent*

*POLYCOM HDX 9000 SERIES VIDEO CODECS HAVE PHOENIX CONNECTO RS FOR AUDIO INPUT/OUTPUT WHILE REVOLABS

SINGLE CHANNEL SYSTEM PRODUCTS USE RCA CONNECTORS FOR AUDIO INPUT/OUTPUT. THE POLYCOM AUDIO ADAPTER

CABLE CONVERTS TWO PHOENIX CONNECTORS INTO FEMALE RCA CONNECTORS. OTHERWISE, A TECHNIC IAN COULD SIMPLY

CUT OFF THE ENDS OF THE RCA CABLES AND CONNECT PER THE DIA GRA M ON THE FOLLOWING PA GE:

1 2 3 4

Revolabs Single Channel System - Polycom HDX 9004 Setup Guide NOTES AND CA UTIONS: This setup guide will guide you through the steps needed to prope

Page 2

Connecting the Cables CONNECTING A REVOLA BS SINGLE CHANNEL SYSTEM TO POLYCOM HDX 9004 VIDEO CODEC 1. Connect a Revolabs 2.5mm to RCA audio cable

Page 4

Configuring the HDX 9004 Video Codec CONFIGURING THE AUDIO MENUS OF THE HDX 9004 VIDEO CODEC 1. Select SYSTEM 2. Select ADMIN SETTINGS and enter t

No comments

Revolabs Single Channel System - Polycom HDX 9004 User Manual